Dingoonity.org

GCW Zero => Help => Topic started by: GeneralJefe on January 16, 2017, 10:02:57 pm

Title: Franken-Zero Support
Post by: GeneralJefe on January 16, 2017, 10:02:57 pm
I was one of the few who received a Franken-Zero early in the Zero's development. I've had it for quite some time, and I used it some around the time that I received it in 2012, however I don't believe I've ever updated it. I would like to do so now, however I'm not sure that I can update it with the updates that are available on the GCW Zero website, as this system differs from most. Would that cause any issue, or would that be fine?

Also, a lesser problem, when I received it, it came with a bezel that must have been misprinted, as the clear section of the screen is offset and covers a portion of the screen. I've attached an image here.
(http://i.imgur.com/oNSB3Tf.jpg)
So, as you can see, the bezel is printed incorrectly and covers the left side of the screen while exposing some of the plastic underneath on the right.

Update: At this point, I've resolved the first issue by using the rescue disc located here:
http://boards.dingoonity.org/gcw-releases/opendingux-rescue-disc-v0-1/ (http://boards.dingoonity.org/gcw-releases/opendingux-rescue-disc-v0-1/)

The bezel, however, is still something I'd like to resolve.
Title: Re: Franken-Zero Support
Post by: CREEPINGIRON on January 25, 2017, 11:43:05 pm
If you need a new Bezel there's Dreamesper.com