Author Topic: Replacement LCD Screen for Dingoo A320  (Read 13793 times)

zwierzaczysko (OP)

  • Posts: 3
Replacement LCD Screen for Dingoo A320
« on: August 24, 2020, 10:17:35 pm »
Hello!

Could anyone tell if it's possible to get a replacement LCD screen for Dingoo A320?

I've searched the internet but without success. I'm from Poland which is a European country.

I would be grateful for any help.

Thank you!


zwierzaczysko (OP)

  • Posts: 3
Re: Replacement LCD Screen for Dingoo A320
« Reply #1 on: October 12, 2020, 07:37:37 am »
Okay, so I did some research to determine the type of screen needed. From what I've found it seems that the Dingoo A320 has a 2.8 inch, 37 pin, 240x320, TFT, no touch LCD screen. Please correct me if I'm wrong.

There are plenty of those on AliExpress and the prices vary around $5. Although the screens have different drivers (symbols starting with ili) and different interface (typically 16 bit). Frankly I have no idea what type of driver is needed and what's the interface, so any suggestions are welcome.

Furthermore I finally had the time to take it apart in hopes of finding symbols on the current LCD, that would lead me to the type required for replacement. Unfortunately googling the symbols from the screen did not give any results.

Photos of the current screen:



So onece again I'm asking you for your support. Thank you!

pcercuei

  • Posts: 1731
    • My devblog
Re: Replacement LCD Screen for Dingoo A320
« Reply #2 on: October 12, 2020, 11:31:39 am »
There were 3 screens used with the Dingoo A320, one with a ILI9325, one with a ILI9331, one with a ILI9338. Do you know which one your A320 had?

zwierzaczysko (OP)

  • Posts: 3
Re: Replacement LCD Screen for Dingoo A320
« Reply #3 on: October 12, 2020, 09:50:56 pm »
Not a clue unfortunately. Is there a way to determine that?

pcercuei

  • Posts: 1731
    • My devblog
Re: Replacement LCD Screen for Dingoo A320
« Reply #4 on: October 13, 2020, 09:52:00 am »
There's a way to read that info in the native firmware's settings if I remember correctly. I don't remember exactly where though.

 

Post a new topic